Hot Rolled Sheet Liquid steel with chemical components adjusted must be rolled after being turned into slabs in Continuous Casting Facilities (casting in Ingot molds is not left in our country). Slab, which is generally 200-250 mm thick, 800-1800 mm wide and 6000-12000 mm long, is rolled to the targeted thickness in Hot Rolling Plants. For this, after the slab is heated up to the rolling temperature in Heating Furnaces, it is first rough-rolled (20-50 mm) and then passed through a series of rolls for final rolling. Flat steel, which has an exit from the rolling mill at 850-940 C degrees, is cooled with water and wrapped in rolls, mostly at 580-750 C. After the roll comes to room temperature, it is shipped as a roll or by slitting or cutting the paint according to the customer's demand. General usage areas In the manufacture of transport vehicles (ships, trains, trucks, buses, automobiles, bicycles) In the energy sector; in energy transmission lines, wind energy generation equipment, power plant structure, solar energy utilization equipment, In the agricultural sector; in the manufacture of agricultural machinery, in the manufacture of tractors, In the construction of pipes used in water, gas and oil transportation, in the construction of canals, tunnels, dams, bridges, ports, in controlling the great power of water, In storage systems, silo construction, container manufacturing, In hot and pressurized environments, in the manufacture of heat exchangers, in the manufacture of steam boilers, Concrete transport in the construction of carrier columns in the construction industry. It is successfully used in the construction of mixing, molding equipment, the construction of steel buildings.